Posted by rrobert on August 05, 2012 at 05:15:00 from (184.108.40.206):
In Reply to: briggs engine posted by Amstrad on August 05, 2012 at 04:41:45:
Set the valves to .004-.005. Over .007 and it will be hard to crank.
Search youtube for a voltage drop test. Very easy test with an ohm meter.
Try using jumper cables directly from vehicle to the starter. It will spark, so make sure no gas is close by. If it cranks over, then you have a voltage drop somewhere from the battery to the starter. Could be the solenoid and could be dirty connections or decayed wires.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.