Posted by joe csuti on July 20, 2012 at 17:43:46 from (22.214.171.124):
In Reply to: ZAMA carb posted by George Marsh on July 20, 2012 at 13:56:42:
If this carb is built same/similar to most walbro carbs an easily/usually over looked item in carb is the 100 mesh screen filter pressed into a cavity in carb body(I don't remember if it's under pump diaphram or metering diaphram)if this screen gets dirty/gummed up it will make eng run lean or not at all without choke,if carb has screen you can clean by carefully removing same from carb body,soaking in carb cleaner then blow out from backside & reinstall or goto link below & type 38-8121 in search,screens are priced each,but only sold in 10 pack,also while there click on chainsaw & look at zama rebuild kits,see if any for your mod# carb.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.