Hi. You are probably all advised out on this one but I've had a little think to see if theres any thing else to suggest. Assuming you have anormal simms pump, when you press the cold start does the rack actually move? you'll need to take the side panel off to check. If the air breather has moisture in it it will freeze up and not allow the damper to move properly. You could try wrapping a cloth around the diaphram and pouring hot water over it. The cloth will retain the heat and get rid of any ice. You have probably already tried removing the air intake pipe and holding a twist of burning newspaper over the intake whilst you use the starter so it sucks hot air into the engine, but its worth a mention. (thats my favourite). Is the butterfly valve in the intake working correctly. If you've already been down these lines then sorry to bother you. Have a nice season. Mike
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.