Hi If you got a vacuum governor and it"s that cold it could be the leather diaphragm is not flexing in the cold. those diaphragms are lightly oiled. and pulled to rev the motor by the difference in vacuum in the 2 lines that come from the intake manifold, so if the oils cold it will be so stiff to move, I think some later ones might of even had a rubber diaphragm in so cold would affect this also. or the linkage in the pumps binding when cold. That would be my guesses as to why it works in the summer and not winter. when you got it running try warming that housing where the pipes go into the vacuum unit on the pump and see what happens,to throttle response. if it"s that diaphragm it should start working right. you do also know the pump has excess fuel button for cold start just at the bottom of the stop linkage. should be a little round push button poking out. Also as others have said you need a block heater of some sort, cranking/ starting it like that when cold will seriously shorten the life of the motor. Had a customer tractor out side this week minus 20oc, just for fun turned the key it would not even turn the motor over. Plugged it in Thurs night went to it yesterday morning( Friday) 2 turns and it fired right up just like plus 30 temps I don"t usually leave them on that long but didn"t have a spare timer around. Regards Robert
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Rebuilt Injection pump for J D 1010. Call or text for pictures or more imformation.free shipping.U.S. No core charge
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.