Posted by Jack Mayers on May 17, 2012 at 12:57:57 from (220.127.116.11):
Split the Dexta and adjusted the PTO screws. Working fine now. Decided to check the injector timing on my 1961 FSM. With the flywheel set at the 21 degrees before tdc the mark on the injector pump is still about 30 degrees off with the adjustment as far as it can go. It seems as if the flywheel is correct watching the rocker arms. Could it be possible the shaft comming from the governer is in the wrong place? Looking for suggestions. The tractor ran before I began to retime the pump but it had little power and was knocking. The manual suggested checking the pump timing. I don't know where to go from here.
PS. I have the pneumatic governor so the seting is 23 degrees, but that won't make much difference.
This post was edited by Jack Mayers at 19:29:28 05/17/12.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.