Posted by BWOODS on September 09, 2011 at 17:41:36 from (184.108.40.206):
I JUST REBUILT MY 1958 FORDSON DEXTA. I REDONE THE WHOLE ENGINE, EVERYTHING NEW EXCEPT THE CRANK WITCH CHECK OUT OK, HAD SLEEVES DONE AT MACHINE SHOP AND DONE THE HEAD ALL NEW PARTS. NOW FOR THE PROBLEM, WHEN I CRANKED IT THERE IS ALOT OF BLOW-BY COMEING OUT OF THE VALVE COVER THROUGH THE VENT PIPE WITH A LITTLE OIL TOO, AND ALSO IT IS PUSHING OIL OUT OF THE DIP STICK, A PRETTY GOOD DRIP. IT RUNS GOOD AND SOUNDS GOOD. WILL IT CLEAR UP WHEN EVERYTHING SEALS OR AM I GOING TO HAVE TO START OVER ???
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.