Posted by Richard hare on May 01, 2011 at 06:07:31 from (206.172.179.118):
In Reply to: FSM timing Q's. posted by Richard hare on April 30, 2011 at 05:50:49:
Thank you for the replies Gentlemen, It appears that the Fordson tractor pages Forum us down at present. I have tried to go there for a few days and it says unavailable.
Reading through past posts here, it Appears that my engine and pump should work together.
Yes Bendee, I think I need the manual! One suggestion I had, was that this pump may be from an engine with the different poump mounting. (Some pumps lean in to-wards the block, and some are mounted upright, depending on whick mounting block is used) I will try another mounting I have, and see if it brings things closer to where they should be. Also, I am sure the pump coupler has been changed, but can't figure out the ramifications of this!...........apart from the possibility that the timing mark may have nothing to do with actual timing! One more question if I may; How close to coreect timing is it, if a tractor runs badly with smoke and missing? As in, are we out a quarter turn on the pump, or are we within 10 degrees, or what?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.