Posted by James White on March 16, 2011 at 20:34:18 from (18.104.22.168):
In Reply to: Oil Pressure ? posted by Farmall Dann on March 13, 2011 at 22:13:58:
Id start by changing the oil, filter, and also take the strainer out of the bottom of the pan and clean it. (Warm up the engine first.)Wix makes a filter for the application. The book calls for 30 wt. but I use 15w40 in mine because of the wear in the motor. Get a known good pressure gauge and pipe it in after the oil has been changed. Hopefully, youll see a marked improvement. If the pressure still falls to zero after its hot then youll need an overhaul.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.