Posted by richard bartlett on January 23, 2011 at 14:25:34 from (184.108.40.206):
I am well on the way to restoring a 1955 FMD and had a lot enjoyment and learnt new ways to curse! However, as usual the replacement parts, in this case from agriline, have needed adjusting to fit. The replacement bonnet is too tight to the upright exhust by about 1/2 inch, admittedly the original bonnet was also too tight and had a hole where the exhust had rubbed it. Any ideas as to how best get around this problem? Cheers Richard.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.