Posted by Majorman on November 09, 2013 at 04:24:03 from (81.153.171.245):
In Reply to: Re: Timing Simms pump posted by Mbaggs on November 06, 2013 at 13:15:03:
Sorry about the delay but my scanner went down.
Couple of questions, why do you think she needs re-timing? Are you having problems starting or running?
If the timing was way out she would not run at all and there are a number of other problems that are not timing related that show similar symptoms, head gasket for one.
Usually the clamp bolt is in the middle of the slots on the coupling but if the timing gears in the front have been replaced wrongly then that could give an offset coupling.
Here are the pictures. If you have no marks and the engine runs, I would move the coupling a little at a time to see if it runs better. If you move it too much you may burn out the pistons or cause other internal damage.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Rebuilt Injection pump for J D 1010. Call or text for pictures or more imformation.free shipping.U.S. No core charge
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.