Posted by kkl on September 30, 2013 at 18:37:29 from (67.133.162.33):
Regarding my 1977 Ford 535:
1. On my left spindle (?), there is a grease fitting on the top and the bottom. On the right, there is no fitting on the bottom. There's a hole, but it doesn't feel like it's threaded. I tried to screw in a Zerk fitting, but there was nothing for it to screw into. What, if anything, can I do about this?
2. The manual says I should grease my front wheel hub, but I don't now how to access this as the diagram shows. It shows the wheel being on. The center may be a cap, but it didn't come off with minimal effort and I didn't want to go after it until I got some advice.
3. My tractor doesn't have an emergency handbrake. Where is the rear axle level plug? Is it #2 (the lower, forward square head in the photo)? It looks accessible in the picture, but it's actually in line with the foot rest, there's no space for a socket, and I don't seem to have a wrench that works on it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.