Not a hard job. Make sure you replace the upper seal - #44, the lower seal - #28, and two orings - #32. Take the hydraulic block apart and clean any rust and crud out of it. Lube with light grease or heavy oil when you reassemble. You will need an I&T FO 20 manual to correctly adjust the spring washer - #42 when you reassemble it. Many people have trouble getting the right plungers in the right holes. As per the photo below the special plungers with the horns go into the hole marked by the pencil. Notice the extra fitting is on the top, right side of the block. You can install the plungers after you set the hyd block back on the column. Install one special plunger horns up, then two balls, then the second plunger horns down. All other holes get a plunger, then a spring, then another plunger. No top or bottom on those. You can call your dealer and get the seals. They are not expensive. Part numbers are: Upper seal - 83929295 Lower seal - 86531349 o rings - 1707280
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.