I looked back into some older posts and I finally found his ebay site, none were listed, probably best to contact him. Not a real hard thing to make, but it sure has to be a common repair on these, I am surprised no part supplier or mfr makes these, makes a niche market for him and thats a good thing. I'm leaning towards a new center piece, if I were to find one used, which would be fine, my concern, especially if found on the net, you really need to take a measurement with a micrometer or something to insure its within tolerance, standard bushing, and or trust someone else who measured the salvage part and will state that its good.
This tractor was about junk when I got it, and 11 years later, having a loader on since new or close to it, hard to imagine given the play the center has to be well worn. I'll keep an eye out, but it seems a new one would be easier, rebuild the core cradle I have and with the rest of the parts, it should be plug and play so to speak. Plan is the spindles first, at least one, move to the garage, then do the rest, thinking at least when done I won't have to worry about that front end coming apart !
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.