Posted by Kirk Grau on March 23, 2013 at 17:23:09 from (98.235.64.137):
In Reply to: Ford 4600 timing posted by Micky Kilpatrick on March 23, 2013 at 14:57:25:
I am going to ask for clarification of "will not crank". If you are saying it does not even turn over/spin (which is how I would interpret "will not crank") I would be looking at starter/battery cables/switch/generally following voltage around to see where the circuit might be broken. If it is spinning, but not fireing, might want to make sure you have the system bled since you removed the pump. Unless you rolled the engine while the pump was off it should not have gotten out of time enough to not be able to start. If you did spin the engine then you need to ask UD to scan the pages from his manual and forward them to you. I have them as well.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.