Posted by lonnie77 on February 10, 2013 at 14:51:24 from (99.101.123.152):
I have a problem with the pto not staying engaged. I replaced the bearing and seal, everything went back together fine. With the engine off the pto shaft will turn either direction. I can engage the pto and turn the shaft only one direction. Then start the engine with it engaged and it will work for about 5-10 minutes. The pto will handle is still up and if I disengage the clutch and try to engage the pto and it will barely engage and then pop out. If I lift the mower the pto will engage and stay engage. There is no movement back and forth with the shaft and about a 1/32 movement up and down.
It is a Diesel 12/4 gear 2wd synchro. The pto speed is set by the rpm I don’t know if that’s multispeed. I have a service manual and I cannot find anything on this type of problem. The shaft slide’s in with a slight turn and fits into a pilot bearing it the rear. Can anyone help me with this?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.