Posted by GLC on January 13, 2013 at 08:47:59 from (141.151.24.138):
I've got a 54 NAA. I replaced the sediment bowl assy. with a new CNH part a few years ago. The aftermarket ones are junk.
The valve on my current sediment bowl works and shuts off the fuel. However, I cannot get the bowl to stop leaking no matter how tight I get it. When the fuel is turned on it just drips ever so slightly and runs down the bowl and drips onto the hydraulic pump. About one drip a minute, but enough to make a mess.
I've used the cork gaskets, and rubber replacements from Tisco and others. I've had the bowl off numerous times and cleaned everything.
I'm thinking about getting another rubber one and using some Permatex to seal it.
Is there a better aftermarket O-ring that will seal and stand today's fuel?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.