Posted by Warren Roberts on January 08, 2013 at 19:49:21 from (22.214.171.124):
Hi I have a Ford 4000 3 cylinder Diesel. It has been super hard to start for the last couple years. So bad that I have to shoot a small amount of starting fluid into the air cleaner to get it going. Once it starts and runs for a few minutes I can turn it off and on all day without any problems. I have 2 suspicions as to what is going on but I want some input. First of all I have a Hi Tourque starter on the tractor, Is it possible that it may not crank the motor over fast enough to get enough compression? or second I feel that the engine has a little too much top end noise for me to be comfortable lately, The more RPM the more noise. Is it possible that the pistons are getting to worn? Creating low compression and a slapping noise? On a side note it also seems to not have much power. Any input would be appreciated.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.