Posted by Ultradog MN on December 29, 2012 at 14:20:56 from (18.104.22.168):
In Reply to: 4400 pto posted by BOBILL on December 29, 2012 at 11:07:53:
This can be caused by a few things. Most likely it is a sticking control valve at the handle. C But it is way too complicated to write it all out here. What repair manual/s do you have for that tractor? You MUST have at least the small (150 page) I&T FO-31 manual and spend some time studying it and THEN ask your questions here. You will also need a gauge that will read about 1000 lbs. You will need to pull the lift cover off to check the pressure. This site sells both the manual and the lift cover casket which you will need. If you have a credit card you can call them at 800 853 2651 and get them shipped to you.
The gauge can be ordered from Northern tool. You will need to make up a couple of fittings to get it to hook up into your tractor. Napa should have some brake line and fittings that will do the job. I had the same problem about 3 or 4 years ago and figured it out with the help of this board. You can too.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.