rodm1 said: (quoted from post at 17:28:43 12/26/12) Where is the oil drain on fill plugs for these?
Always good to start a new topic when changing directions. At any rate, if an early unit, the drain/screen filter should be just below the left foot rest, near the bottom. The drain location has a 1/4" - 20 thread in it that you can run a bolt in to make it easier to remove. There is also a "keeper" over the drain location that needs rotated out of the way. The fill port is on the right side near the same height or above the step. Should have a 4 sided plug in it, many of us add a "street" 90 that threads into the plug location, allowing easier fill and even adding a little extra fluid is a bonus.
This post was edited by NWMO 901 SOS at 09:57:23 12/27/12.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.