Posted by Larry NCKS on December 19, 2012 at 05:43:10 from (184.108.40.206):
In Reply to: Float on remote? posted by Fritz Maurer on December 19, 2012 at 05:12:52:
I don't believe you can open that valve too far. I don't think it will screw out of the body with removing some sort of keeper, either a set screw in the side or a snap ring.
As to Fritz' description, I don't entirely agree. If you don't open that valve for a single acting (one hose) cylinder, the hydraulic system will be putting full pressure against that 2nd port with nowhere for it to go except relief valve.
As to the front plug, I'm not sure what that might be unless it's an alternate for one of the other two.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.