Posted by 10 Bluebird on December 17, 2012 at 12:41:25 from (204.16.161.12):
My tractor threw a rod and I had to get another block. I had a 172 diesel block. The block I got to replace it was Conn6015J. Obviously this was a gas block because when I went to mount my balance gear to mate up with my crank one hole was not bore deep enough and it didn"t have a hole on the other side period. So I took it to the machine shop and they bored and tapped it for me.
I thought my problems were over but when I went to put the head on the bolts do not work, mu block is 5/16s and my old head bolts are 7/16s and the holes that are in the block line up but my head has other holes that are not in the block. Please advise on what I should at this point. If I bore the existing holes from 5/16s to 7/16s and bore additional holes so the head will work, will my rocker arm assembly work valves work right/ etc.?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
