Posted by jokester on November 06, 2012 at 08:58:22 from (184.108.40.206):
In Reply to: ford 4000 lift posted by bob4100 on November 06, 2012 at 07:57:54:
Brandon4000 said: (quoted from post at 17:33:57 11/06/12)
JMOR said: (quoted from post at 17:14:41 11/06/12)
Brandon4000 said: (quoted from post at 11:57:54 11/06/12) I have a ford 4000 that the lift will go up but wont come down. took seat and top plate off and replaced all orings on piston and piston housing, drained and replace oil, reassembled and as soon as i started tractor the lift went to the top and will not lower. what is a common issue, or what should I look for?
Real good chance that either the path from lift cylinder to dump port is clogged with trash or that Control Valve is not moving far enough out to open dump port (maybe simple linkage adjustment).
I assume that the valve is built into the housing that the piston goes in under the seat. if that is correct i could not get it to move while i was cleaning it. didnt force it cause i didnt know how it worked and didnt wanna break it
This post was edited by jokester at 09:00:45 11/06/12.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.