Posted by Kurt-NEPA on September 29, 2012 at 12:07:47 from (220.127.116.11):
In Reply to: 860 PTO Clutch posted by mgriff543 on September 29, 2012 at 06:47:35:
Sounds like your clutch is slipping to me. I'd try to adjust the clutch linkage first. If you decide to replace the clutch, its not too bad a job. Just a bit pricey. Figure $400-600 for a replacement clutch and throw out bearing. I would add a pilot bearing, 2 input shaft seals and a gasket. I just replaced the one on my 660 with Tisco clutch and CNH seals. Its working great so far.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.