Posted by FordTractorMan on September 28, 2012 at 22:09:52 from (220.127.116.11):
In Reply to: Re: Tough leak posted by Bern on September 28, 2012 at 20:44:22:
It probably would have, but I took the plate off the floor of the cab and I could see. Actually, it was the pressure line behind the big suction line that had rubbed against the brake line & got a hole. Wasn't too hard to get loose. Knocked the suction line loose to make room to swing wrench, loosened the line at the pump, then sat on the ground w/back against rt. rear wheel and loosened other end overhead. Hard part was getting line out - so many bends. Ended up cutting it in half & plan to replace w/hydraulic hose of equivalent strength. Should be much easier to route and will tie it away from anything it might rub against.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.