Posted by davida on September 17, 2012 at 10:13:03 from (184.108.40.206):
This weekend I was pulling a round baler for the first time in 10 years. The remotes have not been used since then. I had a hard time keeping the tail gate closed. About the time the roll got ready to tie off the tail gate would pop open. After going though the latch adjustment several times i realized the hydraulic cylinders were creeping back up once I closed the tail gate. If I hit the remote leaver every 20 or 30 seconds to keep the tail gate latched I never had any problems.
How hard are these hydraulic remotes to rebuild? Just o-rings I am guessing. Mine is the single leaver type that sits right under the seat.
I hope this is my problem. When the tail gate is raised all the way up it will leak back down in just a few minutes. It did not do this when I was rolling hay with it years ago.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.