Posted by BobW on March 15, 2012 at 09:11:16 from (50.96.108.31):
In Reply to: Ford 600 hydraulics posted by BobW on February 29, 2012 at 10:32:52:
Despite a blow out of the cardboard gasket we built 1000 psi pressure so I think we can check off the pump and substitute O rings and move on. We replaced all the O rings beneath the plate for good measure.
I looked inside the transmission, we have some water there, but rust on the mating surfaces of the plug suggest water enters there as this tractor sits outside. I noticed some froth and that the oil churns when the engine is running. Is there an oil pump in the transmission?
It sounds like we move on to the unloader valve which looks like it is part of the valve/cylinder assembly attached to the lift cover?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.