Posted by BobW on March 14, 2012 at 14:39:25 from (50.96.108.31):
In Reply to: Ford 600 hydraulics posted by BobW on February 29, 2012 at 10:32:52:
Ran the hose from the pump to the fill port, the oil is a bit milky but no evidence of air bubbles. Flow pulses, I am guessing as each piston is engaged? Installed a 3000 psi gauge in the test port on the lift cover, cranked up, put the draft lever in down position, needle did not move off the stop. Tried all combinations of draft lever and lift control, no pressure indicated. Backed the gauge out of the test port to make sure we had oil coming to it, there was. Let it bleed out a bit looking for air bubbles, saw none. Guess this indicates an internal leak/bypass so we don't build any pressure?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.