Posted by Shaun Wallace on February 25, 2012 at 13:18:04 from (184.79.84.3):
In Reply to: 971 2 speed PTO posted by jake collie on February 24, 2012 at 15:58:00:
With the 540 pto installed you will not get a 1000 pto speed with trans shifted in that position. When installing 1000 shaft the pto box has to be shifted to 1000 position to put 1000 shaft in and with trans in 1000 position then will have 1000 pto speed. I have not seen a 1000-1 3/8-21 spline pto in a 6000 only 1 3/8-6. Someone out there has one. Did ford make a 1000 pto shaft for X01 series? Theres not one shown in parts books or I have looked in rite place.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.