Ford Tractors Discussion Board |
Re: Re: 4000(4 cyl) electrical schematic needed
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jhancock on May 23, 2006 at 11:01:27 from (12.39.160.253):
In Reply to: Re: 4000(4 cyl) electrical schematic needed posted by charles bridges on November 08, 2001 at 13:46:44:
I have a Ford 4000 (3 cyl) gas. It started making a squealing noise so I shut it off. I looked it over and tried to start it, but had no power to anything. Checked battery, it is fine. took generator off and had tested, it was bad. I installed remanufactured generator and hooked everything back up. Still no power to anything. I can"t find any wires shorting out or loose. Could that fuse in the dash keep everything else from getting power? I checked the switch and am getting 12V through the switch in the run position and the start position. I can"t think of anything. Can anyone help?
Replies:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|