Ford Tractors Discussion Board |
Re: NAA rear center housing casting numbers
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by walt on December 31, 2003 at 09:09:14 from (68.60.147.23):
In Reply to: NAA rear center housing casting numbers posted by Frank on December 31, 2003 at 08:38:47:
Just looked at my NAA and it also has the same number as your housings. Ford used and still does today a unique and very logical part numbering system consisting of a base part number and design iterations as well has to the orginal year and model it was released. The NAA refers to the 53/54 NAA models, the 4024 & 4025 are base part numbers and the "C" is the design iteration or design level. Many Unfinished as cast or forged parts had a different base part or design level number. So too make a long saga short the 4024 is the as cast part number - not machined center section and the 4025 most likely refers to the finished machined assembly. The 4024 won't be listed in parts books since you can't buy it and can only buy the finished part Where is your center section cracked? Mine had a crack that went from the bottom of one of the trumpet stud holes to nearly the center of the housing. I had a casting welder repair it. It has a slight puddle to where he repaired it and he siad not to grind it down for strength. It's on the bottom so you really can't see it anyway
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
Looking 4 set 9 bolt hubs 3 1/8 inch to fit 60 to 4010 jd
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|