Ford Tractors Discussion Board |
Adjusting Lift Arm Control Lever
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Allan on January 08, 2001 at 13:00:33 from (207.51.148.88):
My 841 Three point will not come up to top. It comes to within 8 inches to the top, measured at the end of the lift arms, with no attachements (no binding anywhere externally). The control lever seems to be out of adjustment. Three point reaches bottom before lever does and lever is all the way up and lift arms are within 8 inches of top. It is a smooth operator otherwise. No jurking, good response to the position control, and no noise from pump. Also, in draft mode, the lift will not come up with or without load when control lever is pulled up. Any adjustsments? Thanks.
Follow Ups:
Home
| Forums
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Rebuilt Injection pump for J D 1010. Call or text for pictures or more imformation.free shipping.U.S. No core charge
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|