Posted by John(UK) on September 15, 2012 at 07:55:25 from (22.214.171.124):
In Reply to: Rob in OH posted by Richard L on September 14, 2012 at 17:30:25:
Richard, the parts list does not say that they increased the number of studs used on a TO35, they do say that they increased the size of the studs from 7/16" to 1/2" but the number used was the same. The studs were mostly located around the bottom part of the inner Mounting Flange just like the earlier TO30. It does not mention that they increased the number on the Bearing Hub from 6 to 12, although they did as we know. Again they don't give a serial number. It was changed about 1957 from memory I have sent you direct an extract from the Service manual that explains this, but there is no serial number given for the change over. John(UK)..firstname.lastname@example.org
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.