Posted by Richard L on August 25, 2012 at 20:01:15 from (220.127.116.11):
In Reply to: Re: TE 20 posted by Ivan in Mich on August 25, 2012 at 18:58:31:
Ivan if you have a Ferguson TE 20, TO 20, TO 30 parts book look on page 12, numbers 57 and 58 those are the washer and plug that goes into the water neck where the temperature bulb is suppose to attach before you can attach it you need to get a "short" adapter so the bulb has enough room to fit in there. The size of that adapter is 5/8" NF and as short as you can find I am fairly certain. If you haven't purchased the water temp gauge try to find one that has a 48" cord on it. That is just a little longer than you need and anything longer is a waste as you will have to coil it up quite a bit more than the 48 inch one.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.