Posted by Jeff-oh on August 17, 2012 at 07:49:57 from (69.174.58.116):
In Reply to: Lift cylinder part 2 posted by Jason S. on August 17, 2012 at 05:22:51:
Jason, I have all the parts you may need. E-mail me @ TE20ferguson at the domain AOL.com
That said there are a couple of other items to examine.
Where is the steady stream coming from... A crack in the lift cylinder or out the back edge. This may be hard to get the right angle on with out climbing under the trator with a turning PTO so put the cover on if you got one.
If a crack then replacing the cylinder is in order. If coming out the back edge then the piston rings may be gone.
To fix pull the lift cover: Steps: 1: disconnect the 3-point ( both link arms and the draft control spring at the rocker arm. 2: Remove the seat 3: gently pull the lift fork arms off the hydraulic pump"s control valve. (down in the oil) You may need to remove the control fork yoke if you have it (remove bolt from one side is fine) 4: remove bolts around the primiter of top cover note positions (there are 4 long, 3 medium and the rest short bolts I remember, may be a little different) The four bolts in the middle fwd of the seat hold the piston on. Do not remove these at this time. 5: Pull top cover up out of the diffy case be careful of the lift forks (help to have a friend, as it is heavy)
You can now trouble shoot and replace what is needed. The piston can be pulled and new rings replaced if that is needed. If you need a new piston, cylinder etc. then e-mail me and I can hook you up better than the $92.00 new cost.
E-mail me if you have questions or need further assistance. Jeff
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
