Posted by Jerry/MT on August 10, 2012 at 09:47:03 from (220.127.116.11):
In Reply to: Re: TO 20 Tractor posted by Charles in Aus. on August 10, 2012 at 03:15:31:
As I remember it, you place the mower on blocks at the height you wish it to run ay, you then lower the liftllever and exted the top link til it places a compressive load on the top link and then hydraulics responds by incrementally lifting the mower slightly. you lock the top link in that position and go mow. It"s basically a method of making the top link apply loads(the weight of the mower) to the hydraulic system that simulate increasing draft when the mower tries to drop and the control system responds by raisng the mower to hold the height.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.