The oil seal can be purchased locally from anyone who sells oil seals. The size is:- 1-5/8" x 2-1/2" x 7/8", the seal they will often give you is narrower than this but this seal need a seal protector on it then it wont get damaged by grass etc wrapping around it. This protector is usually made of leather, but it could be made of something else now. The narrower seal is no use for this purpose or you will be replacing it again quite soon. You should check the collar on the PTO shaft that the lip of the seal rubs against. If it is marked at all, in any way, it will damage the seal lip and it should be replaced.Use some grease on this collar when you slide the seal onto it. When you refill with oil, use Multi-grade 10W/30 which is a lot better than the original oil that was specified...John(UK)....fergusontractors @ hotmail.com
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.