If it is that bad that it needs replaced, don't waste time, just either do as suggested, split with a chisel or cut it off with an angle grinder or hacksaw. If it is good enough to save, then you need to clamp it down tight into the taper and the nut will screw off. Easy on any thing where the track rod end is in from below, like on a 65. Just put the jack under it and lift the tractor!. On a 35 or TO20 you need a 'G' or maybe you call them a 'C' clamp and about 8 inches of 1/2" flat bar. set the bar on the track rod end and the drag link and put the clamp halfway along it and tighten it real tight. Use the same methods to tighten in the new one. Sam
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.