Posted by Jerry/MT on February 14, 2012 at 14:54:40 from (206.183.116.145):
In Reply to: Re: TO-20 Timing posted by Dick Czuchra on February 14, 2012 at 13:58:21:
The flywheel has an offset stud and only goes on one way. I don"t know what manual you are using but you should get the genuine Ferguson Shop Manual. A lot of this info is in there and you can find them for under $20 plus shpg.
What indications are telling you that the piston is at TDC on the compression stroke with the 7° BTDC timing mark at 6 o"clock? Move the timing mark til it shows 7°BTDC in the notch of the timing hole and look where your piston is at, making sure both the vaves are closed on #1.
An easier way to do this is to pull the #1 plug, hold your finger on the #1 pug hole, nudge the starter till til you feel pressure. That indicates you are on the compression stroke. Now nudge the starter til you see the 7°BTDC in the timing hole and rotate the engine by hand to set the timing position in the timing notch. Then loosen the distributor, pull the plug wire off #1 hold it near a good ground with ignition on, rotate the distributor back and forth til you hear the spark snap. At that point you are statically timed. it may take you af ew times to get it right and when you feel you do, then tighten down the distributor and start "er up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.