Harry Ferguson Discussion Board |
'fixed' hyd valve on 35 - now no output?!
[ View Follow Ups ] [ Post Followup ] [ Return to Harry Ferguson Discussion Board ]
Posted by rockhead on March 30, 2000 at 19:37:59 from (208.199.26.54):
One of the two levers under the front of the seat on my TO35 was stuck. Bought owners manual, took off valve body, freed up valve with some WD40. Then stuck vertical feed tube back down into pump housing, and bolted back on valve body. Now 3PH doesn't lift; additionally I get no flow out of the two hose attachment points, one atop each of the two spools. Pulled off the valve body and I AM getting flow up the vertical tube (sure doesn't take long to figure that out). I am stumped at the moment - anybody know what's going on here. Near as I can tell, I am getting flow up the tube, the flow should branch at the T in the valve body and feed both spools. I think I am getting no pressure to the downstream side of any of the valves (I can take the hose connection plugs right off). I didn't measure pressure at the vertical tube, but judging by how quickly it sprayed all over, assume I am at least getting enough to drive fluid thru the valve bodies. Anybody know what they're doing here? Thanks Bill Vannah; WMass
Follow Ups:
Home
| Forums
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Rebuilt Injection pump for J D 1010. Call or text for pictures or more imformation.free shipping.U.S. No core charge
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|