Posted by Tony in Mass. on February 28, 2014 at 17:22:54 from (71.192.19.81):
In Reply to: rear end oil leak posted by George MacDonald on February 28, 2014 at 13:01:36:
After the hard drive went out, I lost pictures I had of this process. Good news, you may not need to spend any money, bad news, this might take 2 or 3 days. The diff needs to be supported, the oil drained, the trumpet/axle casting needs to come off- with most stuff attached to it- safely, straight and level, not easy without a hard surface floor and roller jack, then clean the hole and stud, retighten the nut, and I double nut them. It took 50 or 60 years to unscrew, and I don't want to have to do the same one twice in my lifetime. Try looking in the archives here and massey forum, you might dig up my pictures and some posts on the subject from a couple years ago.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.