Posted by smittyslilfergie on February 02, 2014 at 16:01:14 from (76.204.113.212):
I have a 1950 fergie to 20, when I bought it the seller went thru all the functions and the 3 point went up and down , the pivot control arm was very touchy . I got home and attached a drag blade which is just a 6 ft plain old blade so its not way heavy. now my 3 point would not move, then it went up til the chains were ready to pop, after a few days the blade dropped on its own . I changed out the fluid which looked like tan lumpy turkey gravy, I had to vacuum it out because it would not flow out the drain . i used a little diesel fluid to clean out the housing , thn re vacumed . Aftr new fluid i thought it was fixed as the lever controlled the up motion but then with no load on the 3 point it went up to max and is again stuck. I did notice the control lever had a few pieces of metal bolted together to make up the linkage to the control valve . also when I moved the lever past the bolt trying to raise the arms the lever linkage moved a little front to back but very little movement. I do not know what else to do but any help would be appreciated. If anyone is close to Howell michigan I would be willing to pay to make this work correct. All I want to do is play with the blade in the snow
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.