It has an amp guage on it that does not work. The wiring is pretty simple and not to hard to explain. The 1 wire on the alternator is connected to the amp guage. Other side of amp guage is run to solenoid. Both sides of start button go to the solenoid. One side of kill switch to same side of solenoid. Pos. battery cable from same side of solenoid to battery. The peice that I now know is ballast resistor has green wire to ignition coil. Then a red wire that splices to kill switch and the other part goes toward alternator and is disconnected? Where should that go. That is all there is to the wiring.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.