Posted by 37Chief on January 31, 2013 at 13:59:00 from (220.127.116.11):
I am attaching a rotary mower to my TO 20. If I set the mower at the right height, before I know it the mower drops. Setting is not constant. So I was just going to drop the rock arms all the way down, and install a adjusting yoke on each side and raise the mower to the desired height and is should stay. Problem is the adjusting box hits the axle housing. I want to know if the rock arms are adjustable. If I could just raise the low point of the rock arms, the adjusting box will not hit. Any thoughts? Stan
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.