Posted by Dan S (NY) on January 29, 2013 at 12:04:18 from (220.127.116.11):
In Reply to: TO 35 Housing posted by miner09 on January 29, 2013 at 10:33:13:
You have to tighten the lower lift arm pin from the inside. If you remove the left hand axle housing and then slide out the ring gear assembly you can get to the nut on both lower lift pins. If the tapered hole in the axle isn't wallowed out you should just be able to tighten it up. In the picture, the pin has been removed from the right side so you only see the hole it goes in.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.