Posted by Jeremy in DE on January 22, 2013 at 12:03:24 from (220.127.116.11):
I'm new to engine work, but after reading a few recent discussions I've got a question.
I recently had my TO30 oil pan off to check bearing clearances. While doing that I noticed it appears that numbers 1, 3 and 4 connecting rods are backward. My manual says "rod correlation marks" should face camshaft and assuming I correctly identified said marks they are backward. Certainly #2 is reversed from the rest.
I take it to reverse them I'd have to pull the head? I'd rather not. I've had it for seven years and never knew, does it matter now just because I do know?
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.