Posted by Jason S. on December 13, 2012 at 09:14:31 from (204.54.36.245):
In Reply to: Re: TO30 lift question posted by Timberlake on December 13, 2012 at 03:54:11:
Yes.If the draft spring is out of adjustment it will change how the lift operates.The correct procedure for the draft spring is to hook up an implement...they recomended a 2 bottom plow but a box blade will do, and with it fully raised you should about .020 clearance between the end of the spring and the plunger.If you dont have a feeler gauge you should just be able to turn the spring by hand when the implement is raised.But, be forewarned that more than likely the plunger will not turn unless it is heated cherry red to break all the years of rust loose.If you try to adjust it and it wont move and you dont heat it, you could bend the fork inside, the control valve can come unhooked and etc. After you adjust the draft spring then adjust the quadrant again. Because when you adjust the draft spring it will change the adjustment of the quadrant.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
