Drain from BOTH drain plugs on left side, drain when oil is hot to get most of the crud out and leave overnight if you can. Re-fill through the plug at side of Gear Change Lever. Fill with 2 gallons at a time and allow to stand for 15 mins before adding another 2 gallons, do this until you have filled the correct amount. DON'T fill more than 2 gallons at any one time as it could run through the oil seal into the Clutch should the seal be worn and leaking, if you I know the seal is OK then you can fill all the oil. Providing you add the correct amount of oil, there is no need to use the dipstick as it does take a while to level out. Just check it the following day. Use 10W/30 Multi-grade oil which will be much better in cold conditions and is fine for summer use too. You appear not to have an operators book for this tractor, if you email me direct at the address below I will send you a copy on-line...John(UK)..firstname.lastname@example.org
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.