Posted by John(UK) on December 03, 2012 at 02:11:48 from (79.76.248.50):
In Reply to: o ring posted by Jr. Roby on December 02, 2012 at 19:24:47:
3/8 x 1/2" x 1/16" (MF part 195561M1) But replace both top and bottom never just one as they compress after being in service for a while and they should be changed every 12 months to prevent high pressure leaks. Be careful when lowering the pipe back into the Pump, you may miss the hole and then you wont have any pressure. What I used to do is fit the pipe into the square plate and then lower the pipe gently, keeping the plate flat and horizontal in all directions so that you have a better chance of finding the hole, it is easy with practice but not so easy if you haven't done it before (its like fishing in the dark) if you have problems doing this, remove the PTO lever and look inside at the front right corner and get someone else to lower the pipe and plate and no bad language when you do it.(see attached picture)..John(UK)....fergusontractors@hotmail.com
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.