You can fit different lengths of lower link arm to these tractors and the stabilizer bars must be the same length or they will bend.Measure centre to centre of the pin holes Fit the brackets under the axle and leave them slack, now fit the pivot pin in the bracket in the hole that is EXACTLY opposite the pivot pin for the lower link arm, it MUST be directly opposite this pin. Now attach the implement using the stabilizer bars and lift it clear of the floor about 6" to 12 " Now swing the implement across the tractor a few times and then making sure that the Top Link is EXACTLY in-line with the tractor (not slightly to one side) and then tighten the brackets under the axle.Those brackets are not mounted correctly, they should have then angle to-wards the transmission.It should take very little longer to mount an implement using stabilizers as one that doesn't use them. Leave them off the tractor until you have the implement mounted and lift it just clear of the floor, attach the tractor end of the bars and then attach the rear end, you should be able to swing the implement side to side slightly to assist you to mount the bars..John(UK)
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
