Posted by John(UK) on December 02, 2012 at 10:32:04 from (22.214.171.124):
In Reply to: PTO Lever posted by Bill in Badger on December 01, 2012 at 18:17:19:
You don't say what tractor you have and the PTO gearboxes are different on the 20/30 and 35 If it is a 35 then it maybe the needle bearing in the end of the Pump main shaft that supports the PTO shaft has collapsed and the shaft are no longer lining up. If it is a 35 remove the Plate with the Lever and check it for moving freely, sometimes they stick and wears a groove on the back of the lever which makes movement difficult. If it is a 20 or 30 take off the Lever plate and see if it is the Lever itself or if that is free it will be the selector on the PTO gearbox on the back of the transmission, it could also be that the PTO is twisted at the front of the Pump and preventing the sliding coupling from moving easily....John(UK)...firstname.lastname@example.org
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.